Description
Use on: Any exterior and interior metallic or wooden surfaces.
Application: Roller, brush, spray or air-less spray gun. Always stir well before use.
Packing: Available in 1 kg, 5 kg , 20 kg or 200 kg.
Thinning: Roller – brush: Thin 5-15% by volume, with DAYLUX’s solvent D200 or white spirit. Spray or airless spray: Thin 20-30% by volume, with DAYLUX’s solvent D200.
Coverage: 13 m²/kg approximately, on a properly prepared surface.
Drying: Touch dry: on a day of around 25 °C touch dry after 1-2 hours. Recoat: After 4-6 hrs. Under cooler or humid conditions, allow longer times. Temperature must be above 5°C during application.
Colour shades: Available in 24 basic colours according to OverLac colorcard.
Note: Clean brushes and other equipment with DAYLUX’s Thinner D200 after application. Application and drying should be done in temperature over 5° C and under normal relative humidity. Ensure good ventilation during application and drying. Use suitable personal protective equipment, as necessary. Store the product without dilution, sealing the container very well. Diluted product should not be re-used because its properties might be altered within time. During storage, keep out the product of sun, frost, extreme heat and humidity.
Ensure that the surface is in sound condition. Use sanding paper on the surface before application. The surface must be dry, free from rust, grease, dust, dirt and poorly adhesive materials and ideally painted with ANTICOR Metal Primer of DAYLUX. Always, stir well before use. After thinning, apply one full coat of and sand smoothly. For a superb finish with exceptional properties, sand the first coat smoothly and apply a second one.
Store in accordance with local regulations .Store in a dry ,cool and well- ventilated area. Containers that have been opened must be carefully resealed and kept upright to prevent leakage.
Harmful if swallowed. Avoid contact with skin and eyes. Repeated exposure may cause skin dryness or cracking. In case of contact rinse immediately with plenty of water and if necessary seek medical advice. Keep out of reach of children. Use only with adequate ventilation. Do not breathe spray mist or sanding dust. Wear eye protection and gloves during application or sanding. A dust particulate respirator should be worn when sanding or spraying.
EU maximum Voc content limit values (Directive 2004/42/CE) for this product (category A/i" One -pack performance coatings ", Type SB): 500g/l This product contains maximum 495 g/l VOCs (ready for use product).
